PoolRx Mineral Unit

PoolRx contains a proprietary blend of minerals that continuously and effectively eliminate algae. The specially treated alloy cylinder is packed with PoolRx mineral formulation. These minerals immediately dissolve out of the cylinder and form a stable residual throughout the pool water for up to 6 months. The minerals eliminate the algae while freeing up low levels of chlorine to be more active and productive in the water. During the pools filtration process the minerals are rejuvenated every time they return and pass through the cylinder. PoolRx works synergistically with a constant low level of chlorine. Residential (0.5 – 1.0 ppm); Commercial (1.0 – 5.0 ppm)

DIRECTIONS FOR USE

It is a violation of Federal Law to use this product in a manner inconsistent with its labeling.

  • Clean or backwash your filter before adding PoolRx and remove all debris from skimmer and pump basket

  • Place the PoolRx unit into Pump Basket or Skimmer Ideally place in pump basket for increased water

  • The PoolRx unit should be added to the pool when the pump has at least 3 to 4 hours left on run This will ensure the minerals completely dissolve out of the unit and through the filter into the pool

  • Pump should run during the heat of the day.

  • The pool should turn over its volume of water at least 5 times per day, this normally requires 6 to 8 hours per day this depends on gallons of your pool and pump flow rate.

  • Do not re-clean or backwash filter for at least 2 weeks after PoolRx unit is installed so minerals can dissolve through the filter, whether it is a cartridge, D.E. or sand filter

Maintenance

Maintain normal pool chemistry ranges:

Chlorine (ppm) 0.5 – 1.0
pH 7.2 – 7.8
Alkalinity 80 – 120
Cyanuric Acid 10 – 80

Replace the PoolRx unit in basket every 12 months.
If algae is coming back or the water looks dull you know it’s time to add PoolRx booster minerals.
Add a PoolRx booster after 4-6 Months if needed.
No need for phosphate removers, algaecides, clarifiers.
PoolRx is not compatible for use with bromine or biguanides.
Do not add Cal-Hypo products directly to your pool, they should be diluted prior to adding to your pool.

ABOUT | GLOBAL OFFICES | MEDIA | CONTACT
 © 2012 PoolRx Worldwide Inc. | 60 Post • Irvine, CA • 92618 • 1-800-376-6579 • 949-502-5851